This example program is for the Advanced Power System (APS) N7900 DC power supply family. 
It demostrates how to create a list of voltage values that can be stepped through using 
a trigger signals. This functionality is extremely useful for application where increasing
throughput is critical. The program uses Labview's VISA driver functions and SCPI commands 
to connect to, control, and communicate with an APS N7900 DC power supply. To connect to 
an N7900 you must either enter its VISA address or its resource name into the box labeled 
"VISA resource address or name" at the top left of the front panel. Both can be  obtained 
using NI MAX. The maximum voltage value of the program is 40V so this program must be used 
on APS N7900 models that are 40V and above. To use it with lower votlage models you must 
change the voltage value(s) in the "VOLT 28" command and "LIST:VOLT 15,25,40,35,28" 
command to voltage values within the power supply's range. This program was created using 
LabVIEW version 8.5. For more information on the Advanced Power System N7900 family go to:
www.agilent.com/find/aps 